In this paper, a new resistive voltage divider having vertically placed resistors is designed. This resistive voltage divider is supposed to be utilized in laboratory medium voltage measurement in the frequency range from DC to 9 kHz where most of the voltage transducers are failed to accurately function. The simulation results, validated by measurements, show a frequency response where the scale factor and the phase error variation ranges are respectively 2 and 4 times better than the ones required by standard IEC 60044-8:2002. These results take advantage from a plate connected to the low voltage section and a shield separating the HV part from the LV arm of the voltage divider. The maximum scale factor deviation from the rated value is about 2.4% and the maximum phase error is about 22.9 mrad. These promising results have been obtained in a wide frequency range up to 9 kHz, which is quite unusual for resistive dividers.

Design and Implementation of a Resistive MV Voltage Divider / Modarres, Mohammad; Giordano, Domenico; Zucca, Mauro; Crotti, Gabriella. - In: INTERNATIONAL REVIEW OF ELECTRICAL ENGINEERING. - ISSN 1827-6660. - 12:1(2017), p. 26. [10.15866/iree.v12i1.10963]

Design and Implementation of a Resistive MV Voltage Divider

Modarres, Mohammad;GIORDANO, DOMENICO;ZUCCA, MAURO;CROTTI, GABRIELLA
2017

Abstract

In this paper, a new resistive voltage divider having vertically placed resistors is designed. This resistive voltage divider is supposed to be utilized in laboratory medium voltage measurement in the frequency range from DC to 9 kHz where most of the voltage transducers are failed to accurately function. The simulation results, validated by measurements, show a frequency response where the scale factor and the phase error variation ranges are respectively 2 and 4 times better than the ones required by standard IEC 60044-8:2002. These results take advantage from a plate connected to the low voltage section and a shield separating the HV part from the LV arm of the voltage divider. The maximum scale factor deviation from the rated value is about 2.4% and the maximum phase error is about 22.9 mrad. These promising results have been obtained in a wide frequency range up to 9 kHz, which is quite unusual for resistive dividers.
File in questo prodotto:
File Dimensione Formato  
9_IREE_pre.pdf

accesso aperto

Tipologia: Documento in Pre-print
Licenza: Pubblico - Tutti i diritti riservati
Dimensione 1.14 MB
Formato Adobe PDF
1.14 MB Adobe PDF Visualizza/Apri
IREE 2017.pdf

solo utenti autorizzati

Descrizione: Manuscript published
Tipologia: Versione editoriale
Licenza: Non Pubblico - Accesso privato/ristretto
Dimensione 604.87 kB
Formato Adobe PDF
604.87 kB Adobe PDF   Visualizza/Apri   Richiedi una copia

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11696/55125
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 4
  • ???jsp.display-item.citation.isi??? ND
social impact